Bissell Symphony All in One Vacuum and Steam Mop 1543E

 
Hands-Free Emptying

Dry Tank Technology
Keeps moisture out so your dirt tank is completely dry.  

Clean Across All Sealed Hard Floors
Use on sealed hardwood, ceramic, linoleum, granite and marble floors

Mop Pad Kit | 1252
Accessories include (1) washable soft mop pad and (1) washable scrubby mop pad.

Instructional Guide – Troubleshooting

No Power

Model #'s 1132, 1543, 1652, 1632, 2747 Symphony Vac & Steam

If your Symphony™ Vacuum and Steam Mop has no power, follow these steps to resolve:
Inspect power cord
- Unplug machine
- Run hand along entire length of power cord > Check plug for damage
- If either the cord (not smooth or exposed wires) or plug (prongs) are damaged
- Test outlet
- Test outlet > Plug in a cell phone charger or small appliance
- If no power to outlet > Test a different outlet in a separate room
- Reset circuit breaker if needed 

No/Low Suction
Symphony All-In-One Vacuum and Steam Mop / PowerFresh Vac & Steam | No / Low Suction
If you are experiencing Low/No Suction, follow these steps to resolve:
Check dirt bin
- Vac Light button should be pressed to activate vacuum suction 
- When pressed Vac Light should illuminate
- Slide lock button/lever on front (located below dirt cup) to left then pull dirt cup out 
- Turn machine on 
- Place hand over motor duct opening located at the top of where dirt bin sits 

Leaking

Symphony All-In-One Vacuum and Steam Mop / PowerFresh Vac & Steam | Leaking

Model #'s 1132, 1543, 1652, 1632, 2747 Symphony Vac & Steam

Follow these steps to resolve leaking from your Symphony

Check filter

-          Unplug steam mop 
-          Remove filter > Firmly grasp sides of filter and pull outward
-          Water filter is located below the water tank
-          Inspect the filter for cracks > Examine rubber gasket for damage

Firmly reinstall filter

-          Reinstall filter > Firmly push filter into place until it sits flush with machine
-          There should be no gaps

  No/Low Steam
If you are experiencing No/Low Steam, follow these steps to resolve: 

Test trigger

-          Unplug machine
-          Test trigger
-          Does trigger make a clicking sound when pressed?
           No – bring to service center 
           Yes > Fill tank with room temperature water 

Check hose
-         Remove water filter
-         Filter is located below water tank on back
-         Hose tube can be removed for easier access 
-         Pull from bottom (sideways) & swing outward to remove 

Check filter
-         Does filter have beads? 
-         No > Check – No steam on foot
-         Yes > Inspect filter & rubber gasket > If cracked or damaged, a replacement should be ordered – check your local A Vacuum Store for replacement parts

Check color of beads in filter
-          Green/White = Normal
-          Blue/Black/Tan = Needs to be replaced
-          Red/Brown/White = Dehydrated beads

Dehydrated filter bead care
-          If filter has beads, soak filter in cold water for 10-15 minutes to rehydrate
-          Return filter to machine
-          Push filter into place until flush with machine
-          There should be no gaps  

Reinstall hose tube
-          Align tabs on the clear tube with notches on machine
-          Swing tube down to align with lower tube
-          Secure into opening
-          Push firmly into place 
-          Plug machine in, test for steam